
Using the Ethernet Port
870USE10110 July 2004 151
Network Design Considerations for M1 Ethernet Processors
Introduction In a distributed control environment, Ethernet can be used as:
an I/O network
a supervisory network
a network that combines I/O and supervisory functions
This section discusses how to design your network to make communication between
related devices as effective and deterministic as possible.
When installed on a new network, the M1 Ethernet processor will obtain the MAC
and IP addresses of other devices on the network. This process may require several
minutes.
When the module is successfully communicating with these devices, if a ring
adapter with battery back up is not present, it is recommended that you stop the
processor and save the user program to Flash. This will save the processor’s ARP
cache and enable it to remember this information if power is lost or removed. If you
do not save to flash, the processor must repeat acquiring the ARP cache information
from the network.
This procedure should also be followed whenever:
a new or substitute device is installed on the network
the IP address of a network device has been changed
Note: Preserve your ARP cache information.
CONTROL NETWORKS MUST BE ISOLATED FROM MIS DATA NETWORKS
To maintain a deterministic Ethernet network, you must isolate Momentum
processor adapters and related devices from MIS data networks. Traffic from MIS
data networks can interrupt communication between control devices, causing your
control application to behave unpredictably.
Additionally, the high message rates that may be generated between M1
processors and I/O adapters may bog down an MIS network, causing loss of
productivity.
Failure to follow this instruction can result in injury or equipment damage.
CAUTION
Comentários a estes Manuais